The structure of the gate and wicket is based on a frame made of a metal profile with a cross-section of 60/80/2 mm. The filling is made of the 80/20/1.2 profiles, spaced close to 80mm. In the construction of gates, wickets and the Verticale A span, a horizontal metal profile with a cross-section of 40/30/3 mm is used as filling.
The span in VERTICALE A is mounted to steel posts using mounting brackets. Each span has factory-prepared holes for assembly. It is also possible to install the span in VERTICALE A to structures made of blocks, split stones or other masonry solutions thanks to the possibility of use glued mounting bracket.
In the structure of the VERTICALE B and VERTICALE C spans, the infill profiles are mounted at the bottom to a special mounting channel. The C-profile can be dug into the ground, covered with decorative stones or can be fully exposed. Special mounting bases available in the set are used to install the span to the C-profile.
In the Verticale B span, an additional 87/60/3 mm U-section is used on top of the infill profiles along the entire length of the structure.
In the Verticale C span, all infill profiles in the upper part have a small hole through which a threaded rod is led in a frame made of an aluminum tube with a diameter of 8 mm. The rod stabilizes the structure of the span, preventing the infill profiles from deviating to the sides.
Verticale A is also available with a system of folding gates in a single leaf gate and standard swing gate.